table corners
Posted: Wed Nov 12, 2014 6:57 am
needed to make 16 6"x6" 14 ga steel corner for table project for my wife.
stopped at several small local fab shops and they were so busy they said 2 to 3 weeks to
cut and bend 90s.
spent an hour or so fabing up 10" metal brake that
only needed to do this one chore.
another hour cutting pieces with sabers and bandsaw.
all bent 80 hours quicker than fab shops.
point here is all the things you can do yourself
if you have some welding ability.
wish i could figure out how to rotate pics.
stopped at several small local fab shops and they were so busy they said 2 to 3 weeks to
cut and bend 90s.
spent an hour or so fabing up 10" metal brake that
only needed to do this one chore.
another hour cutting pieces with sabers and bandsaw.
all bent 80 hours quicker than fab shops.
point here is all the things you can do yourself
if you have some welding ability.
wish i could figure out how to rotate pics.
