Page 1 of 1

Welding cart/Roll away

Posted: Sat Apr 19, 2014 4:23 pm
by KEJ76
image.jpg
image.jpg (60.31 KiB) Viewed 1316 times
Hey everyone. Just messing around the shop and decided to make use of my old Craftsman roll away and make a new home for my Lincoln Pro Mig 180. This will also include my Everlast 256 multi process when I get it. Pretty simple idea, so check it out!

Re: Welding cart/Roll away

Posted: Sat Apr 19, 2014 4:32 pm
by Braehill
They used to sell a fold down work surface for the side of your rollaway box, I have one and I use it as a weld surface by hanging it off the side of my Mig cart. It would work great on your cart since it's made for that type of box anyway. I'm not sure if they still sell them or not, but it might be worth checking into.

Len

Re: Welding cart/Roll away

Posted: Sat Apr 19, 2014 10:10 pm
by KEJ76
Len, as a matter of fact they do and I think I have one for it somwhere. That's not a bad idea. Thanks!!

Re: Welding cart/Roll away

Posted: Sat Apr 19, 2014 10:47 pm
by Superiorwelding
Very creative! Did you put a support across the bottom?
-Jonathan

Re: Welding cart/Roll away

Posted: Sun Apr 20, 2014 12:09 am
by jimbob
I like the angles to trap the bottom of the bottles! Might have to steal that one :)

Re: Welding cart/Roll away

Posted: Mon Apr 21, 2014 9:21 pm
by KEJ76
Johnathan, I did. I used some 1" angle.

Go for it jimbob! It works great.

Thanks guys!