Welding Tips and Tricks

Posted: **Sat Feb 16, 2019 12:41 am**

I started padding beads with 7018 on an old piece of scrap until I had built up quite a block. Then I used a variety of tools to carve and polish it, including a milling machine, band saw, belt grinders, die grinders, carbide burrs, angle grinder with cutoff disk, and even some hand filing.

: block; image1.jpeg (85.12 KiB) Viewed 2227 times

: mill; image2.jpeg (60.36 KiB) Viewed 2227 times

: roughed in; image1(2).jpeg (35.35 KiB) Viewed 2227 times

: finished cat; image3.jpeg (29.84 KiB) Viewed 2227 times

Cheers.
-EB

Posted: **Sat Feb 16, 2019 1:34 am**

The only feline with a minimum tensile strength of 70000 psi...

Posted: **Sat Feb 16, 2019 1:57 am**

That's one tough pussy

Sent from my POCOPHONE F1 using Tapatalk

Posted: **Sat Feb 16, 2019 9:55 am**

Everyone sees something different when they look at a block of steel. Not sure how you found that cat in the middle! But it’s a nice one.

Posted: **Sat Feb 16, 2019 3:53 pm**

Poland308 wrote:Everyone sees something different when they look at a block of steel. Not sure how you found that cat in the middle! But it’s a nice one.

Schrödinger's cat?

Posted: **Sat Feb 16, 2019 4:11 pm**

That's a good one - but it's not in box !

Posted: **Tue Jul 02, 2019 2:02 am**

Your subject is a song title ... I started gigglin... that is all.

Welding Tips and Tricks

here kitty kitty

here kitty kitty

Re: here kitty kitty

Re: here kitty kitty

Re: here kitty kitty

Re: here kitty kitty

Re: here kitty kitty

Re: here kitty kitty