Page 1 of 1
Restoration job cast iron
Posted: Thu May 18, 2017 9:25 pm
by xwrench
So I recently acquired this beauty. I haven't had a chance to do a spark test yet but I'm fairly certain it's cast iron. There's a small crack I need to weld up but cast has always been my Achillese' heel. I'd love to hear any suggestions or comments, thanks.
- File May 18, 7 18 04 PM.jpeg (48.17 KiB) Viewed 1718 times
Cheers.
-EB
Re: Restoration job
Posted: Fri May 19, 2017 6:31 am
by Farmwelding
Where is the crack/do you have a picture of the crack?
Re: Restoration job
Posted: Fri May 19, 2017 6:49 am
by xwrench
Farmwelding wrote:Where is the crack/do you have a picture of the crack?
I'll take a pic of the crack and post it. Meant to do that in the first place.
Cheers
-EB
Re: Restoration job
Posted: Fri May 19, 2017 9:23 am
by xwrench
Here is a pic of the cracked piece. Sorry about it being sideways.
- IMG_0554.JPG (61.46 KiB) Viewed 1669 times
Cheers.
-EB
Re: Restoration job
Posted: Fri May 19, 2017 9:38 am
by xwrench
Here's a view of the other side also.
- IMG_0077.JPG (59.89 KiB) Viewed 1667 times
Re: Restoration job cast iron
Posted: Sun Jul 16, 2017 11:01 pm
by BLURAT
EB,
I sent you a PM. You have a relatively rare swivel base Paramo there. Weighs about 105# as she sits, and is most likely made well before 1950.