Page 1 of 1
New table build
Posted: Sat Nov 05, 2016 12:30 pm
by jroark
Flame maple boards and powder coated frame. Customer totally loved it! That makes my day.
Re: New table build
Posted: Sat Nov 05, 2016 1:22 pm
by Otto Nobedder
How could they not love it? That's a thing of beauty.
How are the boards attached?
Steve S
Re: New table build
Posted: Sat Nov 05, 2016 3:13 pm
by jroark
I've got some 1"x1" angle cut at 1" long welded to where the boards will be flush with the top of the frame. Eight pieces of angle per board. Then drilled holes through the angle and screwed the boards down. I also have a piece of tubing ripped down and spanning the middle of both boards short ways for support.
Re: New table build
Posted: Sat Nov 05, 2016 4:49 pm
by exnailpounder
Beautiful!
Re: New table build
Posted: Sat Nov 05, 2016 9:12 pm
by jroark
Thanks.
Re: New table build
Posted: Sun Nov 06, 2016 7:25 am
by motox
really nice. how did you finish the wood?
I've built several wood/metal tables but
never thought to powder coat..
(even though i have had a dozen
motor cycle frames powder coated)
go figure..
craig
Re: New table build
Posted: Sun Nov 06, 2016 10:22 am
by RamboBaby
That is bad ass!
Re: New table build
Posted: Sun Nov 06, 2016 11:47 am
by Wolfgang
Very nice!!!
Re: New table build
Posted: Sun Nov 06, 2016 3:31 pm
by jroark
I just do a three step sanding process and use Minwax stain and clear. Also use 0000 steel wool to smooth out. Thanks for the nice replies. The powder coated finish really does look good.
Re: New table build
Posted: Mon Nov 07, 2016 8:10 am
by motox
jroak,
thanks, once again project is very nice!
craig
Re: New table build
Posted: Tue Nov 08, 2016 6:11 pm
by Harry72
We need a like button!
Nice work indeed
Re: New table build
Posted: Wed Nov 09, 2016 4:13 pm
by AndersK
I always liked the combo wood-metal
Well done !