Page 1 of 1
Clamp Base for Grizzly Vise
Posted: Tue Sep 27, 2016 10:41 pm
by mickent
This vise base is made from 2x3x 3/8" angle and 3/8" plate. The mounting plate is 6x6" and the opening is about 3 1/4" to fit my 3" square tube welding table. The dual clamp rods 5/8 - 11 threaded rod with contact pads. Yes, of course there are roller thrust bearings under the contact pads, 2100 pound rated, each.
- 3D CAD
- ViseBenchClamp.jpg (11.23 KiB) Viewed 793 times
Re: Clamp Base for Grizzly Vise
Posted: Tue Sep 27, 2016 10:51 pm
by MosquitoMoto
Nice. Neat shop, too. I can almost smell the clean!
Kym
Re: Clamp Base for Grizzly Vise
Posted: Tue Sep 27, 2016 11:01 pm
by Poland308
Good idea! But I've never owned a vice with such a nice paint job.
Re: Clamp Base for Grizzly Vise
Posted: Wed Sep 28, 2016 7:06 am
by exnailpounder
Poland308 wrote:Good idea! But I've never owned a vice with such a nice paint job.
A welding table with nice paint too...somebody has too much free time
Re: Clamp Base for Grizzly Vise
Posted: Wed Sep 28, 2016 11:32 am
by cornmuse
Poland308 wrote:Good idea! But I've never owned a vice with such a nice paint job.
I did, when it was brand new, lasted about 2 minutes, , , ,
Just like when we got a new piece of heavy equipment, "I scratched the paint on that one"
-c-