[Josh MacD]

I finally finished our new fire ring. It’s 14 ga steel, 17” tall, 38” OD and 23” ID. It’s elevated 2.5” off the pad for venthilation. There is some internal bracing and feet. The finish is premature rusting with vinegar, salt and hydrogen peroxide. I sealed it with Flood Penetrol. I welded with MIG welding with .025 wire. I did cheat a bit and pay to have the steel shop plasma cut the top ring and pre roll the rings. I am happy with how the whole thing turned out. Any feedback is appreciated.

Before glass was added

9FC74B70-BA56-42B9-93C5-D479F0A1730A.jpeg (85.73 KiB) Viewed 1756 times

After glass was added

3F510AD6-A594-4AAC-BC15-23CC3EE195C5.jpeg (91.64 KiB) Viewed 1756 times

[Prototypetom]

Can you share you gas setup? Iv been looking at making one in a rectangle box

[tungstendipper]

You got it done! It's beautiful!

[Josh MacD]

Can you share you gas setup? Iv been looking at making one in a rectangle box

I bought a kit off this site.

https://www.spotix.com/fire-pits/fire-p ... -kits.html

It was very simple. I needed a reduced coupler since my supply stub was 3/4”. And I didn’t use their expensive pan. I used the center drop from my top circle cut out. It was very easy. I do need to add a regulator at the meter since the output is a little high.

[Jackomatic211]

I finally finished our new fire ring. It’s 14 ga steel, 17” tall, 38” OD and 23” ID. It’s elevated 2.5” off the pad for venthilation. There is some internal bracing and feet. The finish is premature rusting with vinegar, salt and hydrogen peroxide. I sealed it with Flood Penetrol. I welded with MIG welding with .025 wire. I did cheat a bit and pay to have the steel shop plasma cut the top ring and pre roll the rings. I am happy with how the whole thing turned out. Any feedback is appreciated.

Before glass was added

9FC74B70-BA56-42B9-93C5-D479F0A1730A.jpeg

After glass was added

3F510AD6-A594-4AAC-BC15-23CC3EE195C5.jpeg

looks really nice you did a good job

[Josh MacD]

Can you share you gas setup? Iv been looking at making one in a rectangle box

For what it’s worth, i needed to go back and add in a regulator to take the pressure down to 125,000 BTUs

[OzFlo]

That looks great Josh. I love the patina. Nice work!

[TravisBeard]

It looks great. It might be a dumb question but where is you gas line running to? And what kind of rocks in the top?

Sent from my SM-G955U using Tapatalk

[Josh MacD]

It looks great. It might be a dumb question but where is you gas line running to? And what kind of rocks in the top?

Sent from my SM-G955U using Tapatalk

We planned ahead and have the 3/4” natural gas line riser coming up between the inner and outer rings so that all plumbing is hidden, and protected, inside the steel ring.

The rock is fire glass. It isn’t cheap but we found some online on clearance.

[motox]

great job.
i certainly will never let my wife see this post.......lol
craig