Welding Tips and Tricks

I will be welding (MIG) up some 1/8" mild steel soon for a test. 2f and 3f positions. It's been a little while since I MIG welded, and I don't have access to a MIG welder at this time. Please tell me, what voltage setting and wire speed setting do you recommend starting at? (I know to experiment a bit to see what works best, I just need a very good starting point).

Thanks.

Assuming solid wire and gas... .035? If so, I like to go a little slower on a test and would likely start at 19 and 195 wire speed. All depends on your welding style.

Thanks, Sarge. That is very helpful information. Yes, it will likely be 035. Also solid wire and gas. CO2, I think? Been awhile.


Steph

I'm sure your job is done by now, but for the future, I think that this welding calculator link might be very helpful for you.