THERMAL ARC 251 - SPOOL GUN OPTIONS? PLEASE HELP
Posted: Thu Mar 21, 2013 5:56 pm
I recently picked up a Thermal Arc Fabricator 251 machine and am looking for a spool gun for it. It has a 10 pin connection and I was told by the Tech Support guy at Thermal Arc that the gun I need is a Tweco 90906.
Does anyone on this forum have the same machine as I? If so, do you have a spool gun? can you tell me what kind of results you have had and any feedback or assistance would be much appreciated.
The cost on the 90906 spool gun is approx $1700 (cheapest I could find from a local distributor) so if anyone can give me some advice I sure would appreciate it.
I have heard that you can use a miller spool gun on a thermal arc 251 machine but my machine has a 10 pin connection for the spool gun.
Does anyone on this forum have the same machine as I? If so, do you have a spool gun? can you tell me what kind of results you have had and any feedback or assistance would be much appreciated.
The cost on the 90906 spool gun is approx $1700 (cheapest I could find from a local distributor) so if anyone can give me some advice I sure would appreciate it.
I have heard that you can use a miller spool gun on a thermal arc 251 machine but my machine has a 10 pin connection for the spool gun.