Handler 140 NEWBIE
Posted: Sat Jan 07, 2012 1:55 pm
I am just getting started, learning on my own, and have a Handler 140. My plan is to use gas; not flux-core. Don't want the spatter issues, and have used a small MIG before.
My questions are:
The FIRST project would probably be a small welding table, and if anyone has pictures of such, I'd appreciate it. I suspect maybe an 18"x36" table top (1/4" or 5/16" thick) is what I'm looking at, with maybe 3/16" 2x2 angle iron frame and legs? I intend to put casters on it, to allow it to be moved and stored against a wall in the garage. I have a small, lightweight mig cart already, so I don't have that as a first project.
Any tips/help/photo's would sure be appreciated.
thanks
My questions are:
The FIRST project would probably be a small welding table, and if anyone has pictures of such, I'd appreciate it. I suspect maybe an 18"x36" table top (1/4" or 5/16" thick) is what I'm looking at, with maybe 3/16" 2x2 angle iron frame and legs? I intend to put casters on it, to allow it to be moved and stored against a wall in the garage. I have a small, lightweight mig cart already, so I don't have that as a first project.
Any tips/help/photo's would sure be appreciated.
thanks