Welding Tips and Tricks

Posted: **Thu Feb 14, 2019 5:30 pm**

: welding (20).jpg (48.3 KiB) Viewed 736 times

: welding (17).jpg (38.32 KiB) Viewed 736 times

This is three passes with LN 25 Ironworker loaded with .045 E71T-11 wire. 200 amps, DECP, 238 WFS, 3-arc force, 1-balance. Took a good 1/2 hour to dial in to what you see here. Is this OK, or do I need more adjusting?

Buggsy

Posted: **Thu Feb 14, 2019 6:19 pm**

Heat looks right, travel speed looks erratic.

Posted: **Thu Feb 14, 2019 8:01 pm**

What does it do with the wire speed a little closer to 260 -280 not sure why but that sounds a little slow to me for the amperage

Sent from my XT1254 using Tapatalk

Welding Tips and Tricks

Please look at this weld

Please look at this weld

Re: Please look at this weld

Re: Please look at this weld