Page 1 of 1
Depth of penetration - How much
Posted: Sat Aug 12, 2017 5:36 am
by Brettm357
How much penetration is classed as enough tested 6mm plate with 0.035 flux core wire with 2 different wire speeds
https://imgur.com/gallery/TQrQK
Re: Depth of penetration - How much
Posted: Sun Aug 13, 2017 8:16 am
by Poland308
The penetration looks good on both. What you need to also look for on a fillet weld is thickness. As your looking at your etch you will see the weld has a triangular shape. the leg length needs to be as long as the metal is thick.
- image.jpg (47.73 KiB) Viewed 878 times
Re: Depth of penetration - How much
Posted: Sun Aug 13, 2017 10:31 am
by Brettm357
Ok the right one it is might need to make the weld slightly bigger - thankyou for your guidance
Also what is the book you have in the picture
Re: Depth of penetration - How much
Posted: Sun Aug 13, 2017 7:38 pm
by Poland308
It's one I got through the pipe fitters apprenticeship.