Page 1 of 1
What am I doing wrong???
Posted: Sat Dec 24, 2016 10:39 pm
by ttreb4
I have been trying to weld an end cap on some 2 1/2" pipe. I tried to do this going uphill. I get these big globs. I've tried turning down my settings and it didn't seem to help. It's 1/4" thick pipe with .030 wire.
Re: What am I doing wrong???
Posted: Sat Dec 24, 2016 11:58 pm
by Poland308
Mig on pipe goes better down hill.
Re: What am I doing wrong???
Posted: Sun Dec 25, 2016 10:56 am
by ttreb4
Yes for sure I get a much better looking weld going down hill. Any help for going uphill?
Re: What am I doing wrong???
Posted: Sun Dec 25, 2016 1:56 pm
by cj737
The wiring melting will "sag" due to gravity. About the only way to overcome that is to whip across the middle and sweep up, letting the puddle fill in behind you. It still won't be as clean as downhill, but if you must go vertical up, it will help reduce the bulging.
Re: What am I doing wrong???
Posted: Mon Dec 26, 2016 1:14 pm
by Tommy2069
we never run mig uphill it just don't happen.not saying it can't be done but mig is a downhand wire in my book.
Re: What am I doing wrong???
Posted: Mon Dec 26, 2016 11:56 pm
by ttreb4
Thanks for the help. I'll just keep working at it and do more downhill with MIG.