ryanjames170
- ryanjames170
-
Guide
-
Posts:
-
Joined:Sun Sep 25, 2016 12:46 pm
-
Location:Wisconsin
would running on C10 with my auto Arc 130 vs the door charts C25 settings have caused me to have to run at a much lower wire feed settings? also how dose the heat differ on C25 vs C10? i had to run on Voltage 4 and wire 10 vs charts settings of 4 and wire of 40.
Welder/Fitter
RM Fab & Products
Lincoln Invertec V300 pro
Miller 54D Wire Feeder
Miller 2E DC Welder Generator
Everlast Power IMIG 200
Everlast Power ARC 200ST
Klutch Plasma 275i Plasma Cutter
Hobard/Smith Oxy Torch using propane.
RM Fab & Products
Lincoln Invertec V300 pro
Miller 54D Wire Feeder
Miller 2E DC Welder Generator
Everlast Power IMIG 200
Everlast Power ARC 200ST
Klutch Plasma 275i Plasma Cutter
Hobard/Smith Oxy Torch using propane.