[FarmBoyCustoms]

This is my first big weld job. Learned a lot, but at least the welds are strong and not bad looking. Will make sure to clean everything thoroughly, remove splatter and invest in some wire brush attachments for a drill.

[weldin mike 27]

Good stuff. Also, take that magnet off after taking, before welding. It'll ruin the magnet and could play hurry curry with you weld.

[FarmBoyCustoms]

Ok so use the magnets, clamps check for square. Tac in the pieces, let them cool, take the magnets off and then weld. Gotcha! Thanks for the tip

[weldin mike 27]

No problem mate.

[timothymass]

here is some stainless 304 and a solvent tank I welded up for my garage

[weldin mike 27]

309 flux core on one side, s6 on the other. The s6 didn't etch well.

[weldin mike 27]

309 flux core on one side, s6 on the other. The s6 didn't etch well.

[Hellbilly]

image.jpg (47.23 KiB) Viewed 1211 times

[JDIGGS82]

image.jpg (57.48 KiB) Viewed 1191 times

image.jpg (39.83 KiB) Viewed 1191 times

It's been a long while since I posted how Ya Been guys

[TRACKRANGER]

Nice JDIGGS82

It would be really great if you could advise your settings, amps, machine, wire feed speed, wire diameter, materials thickness, gas flow rate, technique etc. This would really assist others.

Nice job

Trev

[MinnesotaDave]

Torched off some rusted out metal (step area) from my demolition trailer, put some less rusty metal in its place.

.045" hard wire, 100% CO2

Metal

image.jpg (60.75 KiB) Viewed 1123 times

Machine

image.jpg (73.76 KiB) Viewed 1123 times

[rahtreelimbs]

Did this on a 6' x 9' coffee table I welded up for a friend. Lincoln 140 amp machine, 75/25 mix, .023" wire ( if I recall correctly).