Page 2 of 2
Re: Can I Weld This Motor Base With MIG?
Posted: Mon Dec 12, 2016 2:25 pm
by Chips O'Toole
I wasn't kidding!
- 12-12-16 lincoln welder with gas sign small.jpg (42.94 KiB) Viewed 585 times
Re: Can I Weld This Motor Base With MIG?
Posted: Mon Dec 12, 2016 10:12 pm
by MosquitoMoto
Well, I'm glad that worked out well for you.
I only forget the gas...when I'm welding something absolutely critical. If I'm practising or just zapping something of no real consequence, I turn the gas on.
But any time a mate shows up and says something like "I have this hand-formed 1mm thick aluminium aircraft blister cowling that's 75 years old and utterly irreplaceable, do you think you could repair it?" ... THAT is when I will forget to turn the gas on.
Kym
Re: Can I Weld This Motor Base With MIG?
Posted: Tue Dec 13, 2016 12:10 pm
by Chips O'Toole
That makes complete sense to me.
I prefer not to discuss the time I left the gas ON.
Re: Can I Weld This Motor Base With MIG?
Posted: Tue Dec 13, 2016 6:54 pm
by Poland308
That is always a sad day. Out to the shop to weld something up quick. Go to turn on the gas and your first thought is who cranked this valve down because I can't open it? Then you realize
it's already on! SOB I'm an idiot!
Re: Can I Weld This Motor Base With MIG?
Posted: Tue Dec 13, 2016 9:22 pm
by ldbtx
Poland308 wrote:That is always a sad day. Out to the shop to weld something up quick. Go to turn on the gas and your first thought is who cranked this valve down because I can't open it? Then you realize
it's already on! SOB I'm an idiot!
Sure glad I'm not the only one that's done that