Hollywood1
- Hollywood1
-
Ace
-
Posts:
-
Joined:Mon Feb 23, 2015 9:05 am
-
Location:Washington
Trying to get the mig to look like tig. This is one continuous motion, no start and stops. Pull to the right fairly quickly, then slow down a bit for the e loop and repeat. Any comments or suggestions? Thanks, John.
- Attachments
-
- 20160306_121946.jpg (36.18 KiB) Viewed 1275 times
John, looks pretty damn good!
What were your settings?
What were your settings?
I weld stainless, stainless and more stainless...Food Industry, sanitary process piping, vessels, whatever is needed, I like to make stuff.
ASME IX, AWS 17.1, D1.1
Instagram #RNHFAB
ASME IX, AWS 17.1, D1.1
Instagram #RNHFAB
Hollywood1
- Hollywood1
-
Ace
-
Posts:
-
Joined:Mon Feb 23, 2015 9:05 am
-
Location:Washington
Thanks Rick. I just turned the wire feed speed down until it sounded bad and then slowly increased it until you get the first crisp sound of bacon fryin. -e-e-e-e pattern dragin from left to right. John
jeffBrian
- jeffBrian
-
Active Member
-
Posts:
-
Joined:Sun Jan 31, 2016 1:36 am
-
Location:not the right place
that looks really good. I've been out of town working for a friend and just got back last night. I really want to try mig like tig and see what I can do.Hollywood1 wrote:Trying to get the mig to look like tig. This is one continuous motion, no start and stops. Pull to the right fairly quickly, then slow down a bit for the e loop and repeat. Any comments or suggestions? Thanks, John.
Hollywood1
- Hollywood1
-
Ace
-
Posts:
-
Joined:Mon Feb 23, 2015 9:05 am
-
Location:Washington
Thanks!
