I would like to know the formula for calculating the wire feed speed for flux cored mig and could anyone tell me why it is different from wire shielded with gas
Thanks
Welcome to the forum. There very well may be a few "formulas" floating around but I usually just try to start off with The MFG suggestions.
You can probably post your question in the forum at http://forum.weldingtipsandtricks.com/viewforum.php?f=6 or even use the search function.
Have a great day
Gerald
You can probably post your question in the forum at http://forum.weldingtipsandtricks.com/viewforum.php?f=6 or even use the search function.
Have a great day
Gerald
Gerald Austin
If I didn't say it in the post- Have a great day !
Greeneville Tn
If I didn't say it in the post- Have a great day !
Greeneville Tn
- Otto Nobedder
-
Weldmonger
-
Posts:
-
Joined:Thu Jan 06, 2011 11:40 pm
-
Location:Near New Orleans
I'll move this to the appropriate forum...
Steve S
Steve S
- AKweldshop
-
Weldmonger
-
Posts:
-
Joined:Wed Oct 23, 2013 3:30 pm
-
Location:Palmer AK
Why do you need to know the wire feed speed??
Just a couple welders and a couple of big hammers and torches.
Men in dirty jeans built this country, while men in clean suits have destroyed it.
Trump/Carson 2016-2024
Men in dirty jeans built this country, while men in clean suits have destroyed it.
Trump/Carson 2016-2024