[JDIGGS82]

Had a few minutes ti screw around on some scrap today got any pointers or critiques anyone? also a few welds i ran today trying to make them look pretty

v up 1.jpg (53.91 KiB) Viewed 699 times

v up 2.jpg (51.85 KiB) Viewed 699 times

cross member.jpg (35.08 KiB) Viewed 699 times

cross member.jpg (35.08 KiB) Viewed 699 times

[Otto Nobedder]

I have nothing to add but "practice".

Vertical up MIG is a beast for most, especially those used to vertical down. Those welds look fine to me, and can only get better with time.

You're obviously doing it right. Just keep doing it.

Steve S

[JDIGGS82]

Thanks much!