[Floyd9181]

So I am a beginner welder, been wanting to learn forever and finally decided I need to learn if I am to work on my on my old truck project. I purchased a Hobart 140 as it said you could weld up to 1/4 and works with 110v plus I don't plan to go no where near that thick. I also have a few buddies that said that's all i'll ever need. Watched a lot of youtube and got me some flatbar and started running beads. My welding buddies say i'm doing pretty dang good but I always 2nd guess myself

Opinions and thoughts ?

Practice welds

IMG_0127.jpg (86.02 KiB) Viewed 1093 times

[Oscar]

not bat at all. May I suggest a 2" grinder so you can get some roloc sanding disks and some Naval Jelly or similar rust remover or anything that has phosphoric or nitric acid? cutting/polishing/etching tells you a lot more than any "approvals" from the internet.

[Floyd9181]

not bat at all. May I suggest a 2" grinder so you can get some roloc sanding disks and some Naval Jelly or similar rust remover or anything that has phosphoric or nitric acid? cutting/polishing/etching tells you a lot more than any "approvals" from the internet.

thank you..Luckily for me I do learn fast

I have cut these in half, just need to get the stuff to etch it

[Floyd9181]

Few more welds i did on these brackets

IMG_3896.jpg (79.1 KiB) Viewed 1087 times

IMG_3892.jpg (53.48 KiB) Viewed 1087 times

[Oscar]

I've always just used Naval Jelly from Lowes, but while I was at home depot looking for it, they didn't have it so I bough a gallon of Klean Strip Phosphoric Prep & Etch. Let's see how well this one works. I can always use it for de-rusting parts anyways.