Page 1 of 1
2" pipe in 6g root pass
Posted: Fri Jul 17, 2015 4:12 pm
by dejan717
Hello everyone, I am from Serbia.
What do you think of my root pass ?
done freehand, 4 mm gap, 2 mm wire. 2" pipe , wall thickness 4mm
feeding wire through gap
https://www.youtube.com/watch?v=-IdEu3Q_YaU
Re: 2" pipe in 6g root pass
Posted: Fri Jul 17, 2015 8:27 pm
by TRACKRANGER
I think don't lean too far forward at the 9 O'clock position. Where's the safety rail?
Re: 2" pipe in 6g root pass
Posted: Sat Jul 18, 2015 7:05 am
by dejan717
OK thanks. I know that at the 9 o'clock root out a little too much, it's my left hand side.
What do you mean when you say "safety-rail" mean the fence.?
there's no fence, it's my dad's garage
Re: 2" pipe in 6g root pass
Posted: Sat Jul 25, 2015 4:43 pm
by dejan717
Re: 2" pipe in 6g root pass
Posted: Sat Jul 25, 2015 8:49 pm
by TRACKRANGER
dejan717 wrote:OK thanks. I know that at the 9 o'clock root out a little too much, it's my left hand side.
What do you mean when you say "safety-rail" mean the fence.?
there's no fence, it's my dad's garage
Yes, I meant the fence, it looks like a long way down!
Trev
Re: 2" pipe in 6g root pass
Posted: Wed Dec 09, 2015 8:01 am
by dejan717
Re: 2" pipe in 6g root pass
Posted: Wed Dec 09, 2015 11:44 am
by dejan717
Today practicing on carbon steel pipe in 5g position. Diameter of pipe around 5 inch wall thickness is 5mm root gap 5mm filer rod 3mm or 1/8". Amperage 100A