Page 1 of 1
working on my settings
Posted: Thu Mar 26, 2015 6:38 pm
by zank
For my camera
https://youtu.be/QD5nnjhhmsQ
I got a little closer to a nice arc/puddle shot on this one.
https://youtu.be/Je8c8bCU1v4
Jody is a wizard. It's so hard welding around a camera!
Re: working on my settings
Posted: Fri Mar 27, 2015 9:19 am
by Superiorwelding
Zank,
Those are great shots. I have tried before using my phone. You are right, there is a lot more behind the scenes than we think making great welding videos.
-Jonathan
Re: working on my settings
Posted: Fri Mar 27, 2015 11:07 am
by AndersK
Your subscribers just increased with 25%
Re: working on my settings
Posted: Fri Mar 27, 2015 1:34 pm
by motox
zank
settings, material etc if you would
thanks
craig
Re: working on my settings
Posted: Fri Mar 27, 2015 1:56 pm
by zank
You bet. Tubing was 7005 aluminum in sizes ranging from 1.375" OD x 0.052" wall up to 2" OD x 0.157" wall. Filler was 3/32" 5183.
Machine was set at:
Max EN amps and waveshape - 150, Soft Square
Max EP amps and waveshape - 225, Advanced Square
Frequency - 250 Hz
Balance - 80% EN
Torch set up:
20 series
small gas lens with #8 cup
1/16" 2% Lanathanated tungsten
Argon at 18 CFH
Re: working on my settings
Posted: Fri Mar 27, 2015 3:59 pm
by motox
that machine has some serous setting..
craig