Friends
Am trying to get certify for bearing welding but specification cracks comming.Am new for this welding....
parameters using
Miller syncrowave
Amps 230 to 250amps
Post flow time 9 sec
Plate is low carbon for testing 10mm thick
It is not straight LINE welding.that plate has 3 holes 0.22 inches.in that holes 0.22 inch pin has to place and weld for certification.welding around 6 seconds
- TRACKRANGER
-
Weldmonger
-
Posts:
-
Joined:Wed Aug 06, 2014 12:48 am
-
Location:Melbourne, Australia
HiRajasekar wrote:Friends
Am trying to get certify for bearing welding but specification cracks comming.Am new for this welding....
parameters using
Miller syncrowave
Amps 230 to 250amps
Post flow time 9 sec
Plate is low carbon for testing 10mm thick
It is not straight LINE welding.that plate has 3 holes 0.22 inches.in that holes 0.22 inch pin has to place and weld for certification.welding around 6 seconds
Thanks for the request and the detail you already sent
Any chance you can send a photo of the item being welded?
(PS: Welcome also to the Forum)
Trevor
EWM Phonenix 355 Pulse MIG set mainly for Aluminum, CIGWeld 300Amp AC/DC TIG, TRANSMIG S3C 300 Amp MIG, etc, etc