Page 1 of 1
180 syncrowave tig welder
Posted: Sun Mar 30, 2014 9:49 pm
by wagabond
Can I ask a question right away. I am a beginner welder and have purchased a used 180 sd welder. It worked great for about 6 months but, now it will not put out full amp. I found out that if I set it up to 180 amps it will put out 55amps when the foot pedal is pressed full. Could the trouble be the foot pedal or the control board.
ken
Re: 180 syncrowave tig welder
Posted: Mon Mar 31, 2014 5:50 am
by weldin mike 27
Hey mate,
Welcome to the show. I would give miller a ring, they have good tech support.
Re: 180 syncrowave tig welder
Posted: Mon Mar 31, 2014 12:46 pm
by AKweldshop
Sounds like a foot pedal adjustment or something.
Might give miller techs a call(unless they want to charge you)
Or you could ask someone at the Miller forum(I know they don't charge you)
Good luck,
~John
Re: 180 syncrowave tig welder
Posted: Mon Mar 31, 2014 9:14 pm
by paul_s
Welcome to the forum, wagabond.
Re: 180 syncrowave tig welder
Posted: Tue Apr 01, 2014 10:10 am
by Mike
Welcome to the forum wagabond.