Page 1 of 1

My first TIG welds

Posted: Tue Feb 25, 2014 7:42 pm
by smaliden2
Below is a pic of My first TIG welds. Yesterday My new EVERLAST POWER PRO 205S came in and today even though I have no idea how to set up the dam thing, I said what the hell and gave it a go. Any and all criticism welcome.
One thing I noticed was that while welding the aluminum even when I didn't dip in the puddle it almost seemed to jump
up to the tungsten, just wondering if any one knows what causes this.
CAM00274b.jpg
CAM00274b.jpg (99.27 KiB) Viewed 605 times

Re: My first TIG welds

Posted: Tue Feb 25, 2014 7:44 pm
by smaliden2
Here is a pic of the knobs toooooooo many to figure out right now.
205S face PLATE.jpg
205S face PLATE.jpg (89.94 KiB) Viewed 604 times

Re: My first TIG welds

Posted: Tue Feb 25, 2014 7:49 pm
by smaliden2
Does anyone have some type of settings chart for tig cause this manual dont say squat.
in this pic the alum angle on top is 1/16'' and the alum flatbar in the center is 3/16'' and at the
bottom is 1/8 steel square tubing.
CAM00274b.jpg
CAM00274b.jpg (99.27 KiB) Viewed 601 times

Re: My first TIG welds

Posted: Wed Feb 26, 2014 5:35 am
by weldin mike 27
Hey,

Heres something from the main man.

http://www.weldingtipsandtricks.com/tig ... tings.html

Mick

Re: My first TIG welds

Posted: Wed Feb 26, 2014 9:59 pm
by smaliden2
Thanks that was very helpful!!!!