Hastelloy C22 and C276
Posted: Tue Jan 14, 2014 11:33 am
Hi
One of our customer asked us that, if we could make a little pipe job for them. They make "commodities"(not sure about the word) for pharmaceutical industry.
Job itself isn't that difficult. About 3 metres of pipe with one bend and flange, but material is a bit special. Or should I say less known here in Finland. I already read manufactoring guides for hastelloy and came up that it has quite much common with stainless grades. Oxide layer, austenitic phase, specific heat input and etc.
Nevertheless metallurgy wasn't reason for writing here, but asking some advice. Jody have one helpfull video of nickel alloys, thanks
Is there something special that should be kept in mind, when working with these alloys? Is there any ppm limits or colouring for root? Normal argon works in shielding gas and in root?
Also what about prizes? Nickel of course is quite expensive, but 250 dollars for(1kg / one package) of (2.4 mm / 3/32) tig rod feels a bit high.
Text may have some grammar erros, but hopefully readable
-Markus-
One of our customer asked us that, if we could make a little pipe job for them. They make "commodities"(not sure about the word) for pharmaceutical industry.
Job itself isn't that difficult. About 3 metres of pipe with one bend and flange, but material is a bit special. Or should I say less known here in Finland. I already read manufactoring guides for hastelloy and came up that it has quite much common with stainless grades. Oxide layer, austenitic phase, specific heat input and etc.
Nevertheless metallurgy wasn't reason for writing here, but asking some advice. Jody have one helpfull video of nickel alloys, thanks
Is there something special that should be kept in mind, when working with these alloys? Is there any ppm limits or colouring for root? Normal argon works in shielding gas and in root? Also what about prizes? Nickel of course is quite expensive, but 250 dollars for(1kg / one package) of (2.4 mm / 3/32) tig rod feels a bit high.
Text may have some grammar erros, but hopefully readable
-Markus-