Miller Syncrowave 200
Posted: Sat Jul 10, 2010 2:51 pm
This is my first post so hello to all out there.
I have been welding as a hobby for almost 30 years (gas, mig, stick) and recently purchased my first TIG machine. It is a Miller Syncrowave 200. I guess I am getting better at it as time goes by but I am guilty of not practicing like I should.
I have seen a lot on this site about inverter machines and I am just curious, did I waste my money by buying a square wave machine? When do you need an inverter machine and what would I notice different about the welding process from my machine?
Thanks in advance,
Steve
I have been welding as a hobby for almost 30 years (gas, mig, stick) and recently purchased my first TIG machine. It is a Miller Syncrowave 200. I guess I am getting better at it as time goes by but I am guilty of not practicing like I should.
I have seen a lot on this site about inverter machines and I am just curious, did I waste my money by buying a square wave machine? When do you need an inverter machine and what would I notice different about the welding process from my machine?
Thanks in advance,
Steve