TungstenMate - which rotary tool have you succeeded with?
Posted: Wed Jun 30, 2021 12:24 pm
A while back I bought a tungsten mate simplicity to use with an old Dremel 3000 I had laying around.
https://www.tungstenmate.com/product/tu ... implicity/
Their website is clear if slightly annoying in not recommending specific rotary tools that are compatible. The threading on my Dremel is compatible but I cannot manage to set the diamond disc low enough. as you can see I have the shaft all the way into the mandrel and the accessory screwed all the way onto the tool but still the tungsten ends up below the face of the disc. Am I doing something stupid or does this just not work with my rotary tool? Can anyone tell me a model of tool that does work? I would be looking for some thing in expensive as I already have a very nice Proxxon but it is unthreaded.
https://www.tungstenmate.com/product/tu ... implicity/
Their website is clear if slightly annoying in not recommending specific rotary tools that are compatible. The threading on my Dremel is compatible but I cannot manage to set the diamond disc low enough. as you can see I have the shaft all the way into the mandrel and the accessory screwed all the way onto the tool but still the tungsten ends up below the face of the disc. Am I doing something stupid or does this just not work with my rotary tool? Can anyone tell me a model of tool that does work? I would be looking for some thing in expensive as I already have a very nice Proxxon but it is unthreaded.
- IMG_3362.jpg (62.17 KiB) Viewed 685 times
- IMG_3360.jpg (56.27 KiB) Viewed 685 times
- IMG_3363.jpg (46.61 KiB) Viewed 685 times