Page 1 of 1
Brazing withTIG?
Posted: Thu Dec 08, 2011 12:56 am
by derailment
I have a project where I need to join steel and copper sheet with a lap weld. Advice so far is to use silicon bronze rod and only heat to fill the gap with rod. Any advice or recommendations?
Re: Brazing withTIG?
Posted: Thu Dec 08, 2011 6:59 pm
by Greg From K/W
I would do it that way. Sheet steel used to be only joined with brazing rod in body work why not to brass or copper? Now it is done with a mig welder.
Re: Brazing withTIG?
Posted: Wed Jan 04, 2012 8:00 pm
by nova_70_383
alumibronze rod will work too. some places call it A2 or A10