[jtybt]

Jody,
I'm a noob so bare with me.

Been reading the Email tips. Trouble is the Everlast TIG settings ain't quite the same as American made and the instruction pamphlet musta been written by a dummy.

Can you give me some tips on setting things for aluminum? I have straight Argon with the green tungsten but I have 2% thorium.

Is pulse ON or OFF? And what does the frequency/amps/time settings for it do?

What AC frequency(20-250) should I set it to along with the balance(30%-70%)?

There is a 4T/2T switch. What should that be set to?

Thanky,
Charlie

[jtybt]

OK!
I found the frequency and balance parameters on the Miller link. Takes a while for a noob to navigate.

Still need to find out the 4T/2T switch and what and when to use the pulse settings.