Page 1 of 1
Thanks Jodie for showing me how
Posted: Tue Apr 17, 2018 3:08 am
by malmac
- MAL_9574.jpg (34.83 KiB) Viewed 819 times
Thank You Jodie
Broke a tap off in a workpiece.
Looked at you video on how to TIG weld a nut to a broken stud/tap.
Followed your instructions and no worries - got the little sucker out.
Mal
Re: Thanks Jodie for showing me how
Posted: Fri Apr 20, 2018 11:27 am
by pgk
Hate it when that happens..
Re: Thanks Jodie for showing me how
Posted: Fri Apr 20, 2018 2:30 pm
by Downwindtracker2
Taps sometimes just fatigue .
Re: Thanks Jodie for showing me how
Posted: Mon Apr 30, 2018 8:47 pm
by R32Guy
By necessity thread taps are very hard and brittle. Any side loading when turning them can cause them to fracture. Jody's tips are valuable IME and I too thank him for sharing his expertise and real world experience.