Page 1 of 1
Add Miller Coolmate to Square Wave TIG 200
Posted: Tue Jun 13, 2017 9:00 pm
by bowleggid
Has anyone added a Coolmate torch cooler to a Lincoln Square Wave 200 ??
I like the feel of the #9 torch, but it's rated 125 amps. I want to weld heavier aluminum and add helium to push the limit of my Square Wave 200 up some, and was thinking of getting a #20 torch (liquid cooled) and adding a Miller Coolmate to it (as economically as possible -- whatever used one I can find on eBay.) Any ideas / feedback?
Re: Add Miller Coolmate to Square Wave TIG 200
Posted: Tue Jun 13, 2017 9:39 pm
by rick9345
just do it. cooler is for the torch does not really concern the power source. Just remember to have the cooler running before welding.
Can also use constant water loss from a faucet.
Re: Add Miller Coolmate to Square Wave TIG 200
Posted: Thu Jun 15, 2017 5:13 pm
by pgk
Lol For sure, been there done that. Luckily I didn't damage the torch or lines.. I have this one:
http://www.ebay.com/itm/Black-Miller-Co ... 2354715143
Good luck!!
Pete
rick9345 wrote:just do it. cooler is for the torch does not really concern the power source. Just remember to have the cooler running before welding.
Can also use constant water loss from a faucet.
Re: Add Miller Coolmate to Square Wave TIG 200
Posted: Sat Jun 24, 2017 4:20 pm
by bowleggid
Thanks, guys. Appreciate the feedback.
Re: Add Miller Coolmate to Square Wave TIG 200
Posted: Sun Jun 25, 2017 1:53 pm
by jauguston
I did it to my Miller Diversion 180. 20 torch with super flex 25' hoses and a home made cooler using a vending machine cooling pump and tank from e-bay. Added a Jattus Tig Perfect pulser and a Smith Equipment Argon/Helium mixer from e-bay.
I am not nearly as good a welder as it is
Jim