I didn't bother checking the gas or puting too much effort in the scrap - it was pretty dirty and the filler was gross too.
Anyhow, did this on a Miller Aerowave using a #8 gas lens around 18 / 28 cfm.
Tried welding on some 0.015 CP2 metal but I'm getting nowhere with that currently.
Re: Wasting time on Titanium scrap (not 56k friendly)
Posted: Sat Jan 29, 2011 7:14 pm
by karlevo8
seemings you didnt clean it up first thats come out well
Re: Wasting time on Titanium scrap (not 56k friendly)