[Coolidge]

Time for paint!

[exnailpounder]

The usual suspects have jacked my thread again

No Jeff and I haven't done it this time. And besides it kind of looks like you did it to me.

Don't sweat it Nick...he's full of shit. Oh...did I hi-jack another thread again?

[Farmwelding]

The usual suspects have jacked my thread again

No Jeff and I haven't done it this time. And besides it kind of looks like you did it to me.

Don't sweat it Nick...he's full of shit. Oh...did I hi-jack another thread again?

I guess so-can't go five minutes around here I guess.

[Coolidge]

Pay no attention to these two jokers jacking my thread ^^^ should I hire this girl to model my new welding cart?

[Otto Nobedder]

If this keeps up, we're going to have a "safety meeting". The occasional thread hi-jack, where the OP plays along, is funny. Making a game of it in many threads is not.

Forrest: "And that's all I have to say 'bout that."

[Otto Nobedder]

Okay, that was some f*!ing ironic timing.

[Coolidge]

Finished!

[Farmwelding]

Must be a Seattle Seahawks fan with the green and blue color

Looks nice and I'm sure you won't be disappointed by anything on that cart

[Coolidge]

Thanks, I was surprised the cart came out flat and rolls on all 4 wheels. One thing though, my tungsten electrodes (I snapped them in half short half length) look like crap, all dark and burnt looking all along its length. I was using the air cooled torch at times near its limits. It seemed like I was struggling way to much with welding up this cart, hard to see the arc and puddle, I'm wondering if something wasn't off there. I reground my tungstens frequently. I was getting a lot of POP craters at the end of my beads. Had the argon about 18 cfm, #8 gas lens, maybe too much stick out?

And no we are Steelers fans in our house we don't like the SeaChickens.

[pgk]

Sure is a fine looking cart

Pete