Looking at the CK master series CK150
One or two piece cable?
Haven't really used air cooled torches in my career, looking for advice. This will be used with a small inverter
to do occasional portable work at the shop.
Also using a remote amp control, rotary or linear? I think I may prefer the linear.
- MosquitoMoto
-
Weldmonger
-
Posts:
-
Joined:Sat Aug 01, 2015 8:38 am
-
Location:The Land Down Under
Hey Richard.
I use the one-piece cable type, usually on #17 torch with a stubby gas lens setup, with amps ranging from 20 or so up to about 175 in short bursts. The one-piece cables I've tried are just so much lighter and more flexible than the two piece jobs that there's no comparison.
Sorry, can't comment on the remote amperage options, I'm either on the pedal or controlling with torch switch and some up-and-down slope options.
Kym
I use the one-piece cable type, usually on #17 torch with a stubby gas lens setup, with amps ranging from 20 or so up to about 175 in short bursts. The one-piece cables I've tried are just so much lighter and more flexible than the two piece jobs that there's no comparison.
Sorry, can't comment on the remote amperage options, I'm either on the pedal or controlling with torch switch and some up-and-down slope options.
Kym
What about a Flexloc? I use a master series Flex-lock with the super flex cable...very happy, Maxstar 150sth
- Attachments
-
- IMG_20160814_184354186~2.jpg (75.08 KiB) Viewed 322 times
I weld stainless, stainless and more stainless...Food Industry, sanitary process piping, vessels, whatever is needed, I like to make stuff.
ASME IX, AWS 17.1, D1.1
Instagram #RNHFAB
ASME IX, AWS 17.1, D1.1
Instagram #RNHFAB