Same thing happens with my Miller Diversion 180.Otto Nobedder wrote:Anyone else notice this? Steve S
- castweldsolutions
-
Active Member
-
Posts:
-
Joined:Wed Jun 10, 2015 1:48 pm
-
Location:Memphis Tennessee
Tyler
20+ yr old Syncrowave 250 some times likes the touch the tungsten first.
seems the tungsten gets contaminated depends on material and or its coating giving off fumes or the underside fuming.
can't always duplicate when trying, I just blame it my torch technique
seems the tungsten gets contaminated depends on material and or its coating giving off fumes or the underside fuming.
can't always duplicate when trying, I just blame it my torch technique
Everlast 250EX
Miller 250 syncrowave
Sharp LMV Vertical Mill
Takisawa TSL-800-D Lathe
Coupla Bandsaws,Grinders,surface grinder,tool/cutter grinder
and more stuff than I deserve(Thanks Significant Other)
Miller 250 syncrowave
Sharp LMV Vertical Mill
Takisawa TSL-800-D Lathe
Coupla Bandsaws,Grinders,surface grinder,tool/cutter grinder
and more stuff than I deserve(Thanks Significant Other)
- Metal_pig2001
-
Active Member
-
Posts:
-
Joined:Sat Aug 16, 2014 3:21 am
-
Location:Rotorua, New Zealand
It would be interesting if some sort of Miller representative was prepared to comment. Possibly a question better posed on the Miller forum I guess.
Regards
Ralph
Regards
Ralph
Metal_pig2001 wrote:It would be interesting if some sort of Miller representative was prepared to comment. Possibly a question better posed on the Miller forum I guess.
Regards
Ralph
I would also like to have the tech who reset the "gap" on a dynasty to come on here and tell us where that is as well and what "coil" did he rewind ????