dave powelson
- dave powelson
-
Guide
-
Posts:
-
Joined:Mon Nov 24, 2014 3:09 am
-
Location:yuba city, CA
......and the joint is butt, T, lap, or ???
- TRACKRANGER
-
Weldmonger
-
Posts:
-
Joined:Wed Aug 06, 2014 12:48 am
-
Location:Melbourne, Australia
your mentioned 24 gauge to 10 ss
presumably to 10 gauge (0.128")
If so, that's a big change in sizes.
Like has been mentioned, what sort of joint? Lap/butt might be challenging. Corner fillet will allow you better control of the heat direction, but little more info can assist.
presumably to 10 gauge (0.128")
If so, that's a big change in sizes.
Like has been mentioned, what sort of joint? Lap/butt might be challenging. Corner fillet will allow you better control of the heat direction, but little more info can assist.
EWM Phonenix 355 Pulse MIG set mainly for Aluminum, CIGWeld 300Amp AC/DC TIG, TRANSMIG S3C 300 Amp MIG, etc, etc