Page 1 of 1
Beveling pipe question
Posted: Thu Dec 02, 2010 11:56 pm
by JeffCanforaCA
What no attachment for hand torch to bevel us some pipe?
At home practicing 6G. Got good info off this site for 1/8" root opening and 1/8" land. But how bout included angle? Guessin' 45*, for 22.5 per side. Gracias
Re: Beveling pipe question
Posted: Fri Dec 03, 2010 3:21 am
by JeffCanforaCA
Looks like 60-75. I see nothing on my 45 guess. Like the 75, like to fill wider gaps. Plus d1.1 tube cert test shows 37.5 single bevel. Other end is square. Ain't nothin like knowin for sure...
Re: Beveling pipe question
Posted: Thu Dec 09, 2010 10:07 pm
by kermdawg
Usual bevel angle on schedule 40 is 30-37.5, for a groove angle of 60-75 degrees. I think your allowed +/- 2.5 degrees (someone correct me on that?). Again, thats for schedule 40 carbon steel.
Re: Beveling pipe question
Posted: Sat Jan 22, 2011 5:40 pm
by welder57
depends on code-5 deg plus or minus
Re: Beveling pipe question
Posted: Sun Jan 30, 2011 4:16 pm
by kermdawg
Thats 5 degrees on the groove angle right? Sounds about right cause that would be 2.5 bevel angle.
Re: Beveling pipe question
Posted: Thu Oct 27, 2011 10:28 am
by QANDT
Mil-STD-22D is a great source for joint designs uses AWS A2.4 a source it can be found here
http://www.everyspec.com/MIL-STD/MIL-ST ... 22D_21685/
Re: Beveling pipe question
Posted: Wed Feb 29, 2012 5:32 am
by harleyotto
depends on code-5 deg plus or minus????