Page 1 of 1
Hello from N East Ohio
Posted: Mon Jul 14, 2014 9:09 pm
by grthcharle
Sorry about that Otto. Vertical stick weld. Used 7018 1/8 rod preheated. Preheated 1 inch plates with backer plate and 1/4 root. Been welding a long time but never got certified. Was welder in Steel Mill that shut down. Any advice would be appreciated.
Re: Hello from N East Ohio
Posted: Mon Jul 14, 2014 9:26 pm
by Otto Nobedder
No sweat. Give me a minute or two, and I'll put your post in the stick forum...
Steve S
Re: Hello from N East Ohio
Posted: Mon Jul 14, 2014 9:43 pm
by Superiorwelding
What are your specific questions?
-Jonathan
Re: Hello from N East Ohio
Posted: Tue Jul 15, 2014 9:13 am
by Mike
Welcome to the forum.
Re: Hello from N East Ohio
Posted: Tue Jul 15, 2014 7:04 pm
by Otto Nobedder
grthcharle,
I apologize... I somehow didn't move the question with the topic.
I'll see if I can drag it here.
Steve S
Re: Hello from N East Ohio
Posted: Tue Jul 15, 2014 7:07 pm
by Otto Nobedder
grthcharle,
I tried to go to the original post, but it's gone... Probably my mistake. It happens, on occasion, while shuffling posts around.
Please re-post your original question and we'll give it the attention it's due.
Steve S