grthcharle
- grthcharle
-
New Member
-
Posts:
-
Joined:Mon Jul 14, 2014 3:41 pm
Sorry about that Otto. Vertical stick weld. Used 7018 1/8 rod preheated. Preheated 1 inch plates with backer plate and 1/4 root. Been welding a long time but never got certified. Was welder in Steel Mill that shut down. Any advice would be appreciated.
- Otto Nobedder
-
Weldmonger
-
Posts:
-
Joined:Thu Jan 06, 2011 11:40 pm
-
Location:Near New Orleans
No sweat. Give me a minute or two, and I'll put your post in the stick forum...
Steve S
Steve S
- Superiorwelding
-
Weldmonger
-
Posts:
-
Joined:Thu Jan 24, 2013 10:13 pm
-
Location:Eddy, TX
What are your specific questions?
-Jonathan
-Jonathan
Instagram- @superiorwelding/@learntotig
Twitter- @_JonathanLewis
https://www.learntotig.com
https://www.superiorweldandfab.com
https://www.youtube.com/+SuperiorWeldin ... ATHANLEWIS
Twitter- @_JonathanLewis
https://www.learntotig.com
https://www.superiorweldandfab.com
https://www.youtube.com/+SuperiorWeldin ... ATHANLEWIS
- Otto Nobedder
-
Weldmonger
-
Posts:
-
Joined:Thu Jan 06, 2011 11:40 pm
-
Location:Near New Orleans
grthcharle,
I apologize... I somehow didn't move the question with the topic.
I'll see if I can drag it here.
Steve S
I apologize... I somehow didn't move the question with the topic.
I'll see if I can drag it here.
Steve S
- Otto Nobedder
-
Weldmonger
-
Posts:
-
Joined:Thu Jan 06, 2011 11:40 pm
-
Location:Near New Orleans
grthcharle,
I tried to go to the original post, but it's gone... Probably my mistake. It happens, on occasion, while shuffling posts around.
Please re-post your original question and we'll give it the attention it's due.
Steve S
I tried to go to the original post, but it's gone... Probably my mistake. It happens, on occasion, while shuffling posts around.
Please re-post your original question and we'll give it the attention it's due.
Steve S