Only time I see 6010 used is for open root. I am fabing a forklift attachment for a front end loader. Will have 3/8 plate for the attachment areas. Since this is the critical and heavily welded part, I was thinking about putting 6010 on a root pass, as it has deeper penetration, but never see it used on non-open root beveled parts.
Boomer63
- Boomer63
-
Heavy Hitter
-
Posts:
-
Joined:Fri Sep 12, 2014 11:52 am
-
Location:Indiana near Chicago
Try running the 6010 for your root, and spend a little bit of money and get some 7018 X 1/8" for fillers and cover.
AWS Classification:
60 = 60,000 LBS. guaranteed minimum tensile strength of filler metal
70 = 70,000 LBS. guaranteed minimum tensile strength of filler metal
1 (just after the 60 or 70) = position; 1 = all position.
8 = (as in 7018) is the odds of you winning the lottery; 8 is less than 552,166,802 to 1; for you.
Take some pics of the project and post them up!
Gary
AWS Classification:
60 = 60,000 LBS. guaranteed minimum tensile strength of filler metal
70 = 70,000 LBS. guaranteed minimum tensile strength of filler metal
1 (just after the 60 or 70) = position; 1 = all position.
8 = (as in 7018) is the odds of you winning the lottery; 8 is less than 552,166,802 to 1; for you.
Take some pics of the project and post them up!
Gary
Here are pics of the first one I built. Already had a 3 point forklift attachment and adapted for the Mahindra. Used 7018.
Since I used it so much, I'm bldg another to sell. Fabing the forks myself this time.
The forklift attachment can lift the tractor and beyond max capacity of the hydronic pump.
Since I used it so much, I'm bldg another to sell. Fabing the forks myself this time.
The forklift attachment can lift the tractor and beyond max capacity of the hydronic pump.
- Attachments
-
- IMG_1235.JPG (100.69 KiB) Viewed 526 times
-
- IMG_1142.JPG (98.76 KiB) Viewed 526 times
-
- IMG_1139.JPG (64.65 KiB) Viewed 526 times