[niftyweld]

it says there are 3 steps, so you guys tell me


First change the polarity to D/C Electrode (-) negative.
Second take a air cooled TIG torch and hook it up to the stinger or electrode holder.
Third take the gas supply hose and attach it to a regulator on a bottle of Argon.

[Artie F. Emm]

Here's an excellent video on that very topic:
http://www.weldingtipsandtricks.com/scr ... setup.html

Please note the power cable adaptor is electrically hot, so you may want to figure out a way to insulate it. A subsequent video shows enclosing it with a plastic water bottle to prevent accidental contact/short circuiting.

Good luck with it, let us know how it goes!

[MinnesotaDave]

it says there are 3 steps, so you guys tell me


First change the polarity to D/C Electrode (-) negative.
Second take a air cooled TIG torch and hook it up to the stinger or electrode holder.
Third take the gas supply hose and attach it to a regulator on a bottle of Argon.

Yes, that's it

[niftyweld]

Here's an excellent video on that very topic:
http://www.weldingtipsandtricks.com/scr ... setup.html

Please note the power cable adaptor is electrically hot, so you may want to figure out a way to insulate it. A subsequent video shows enclosing it with a plastic water bottle to prevent accidental contact/short circuiting.

Good luck with it, let us know how it goes!

Oh thank you thank you so much!!!