CKworldwide MT200

Charliem · Mon Jun 12, 2017 5:47 pm

Hello eveyone,

Does anyone here have any experience with the MT200 tig welder from CK? I am in the market can't decide between that or the everlast. any feed back on it is welcome.

Regards
Charlie

LtBadd · Mon Jun 12, 2017 9:58 pm

hey Charlie, welcome to the forum
What are you going to use the machine for, hobby or business use? have you considered the Lincoln TIG 200 Square wave?

Charliem · Tue Jun 13, 2017 5:08 am

Hello,

I have looked at those and I don't like how that machine starts the arc. Meaning that its not soft enough. Both the Mt200,
And any of the everlast I have seen start as low as 5 amps. To answer your question of whts it going to be used for.. a little of both.

Charlie

sedanman · Tue Jun 13, 2017 8:59 am

Have a look at the Razorweld ac/dc200. Razorweld makes the CK machine. I have one of these units and like it very well. It's not quite as awesome as my HTP 221 bit it is a thousand dollars less expensive.

CroomWelder · Tue Jun 13, 2017 2:08 pm

They do look good i might add.. and its (Mr Tig) approved (whatever that meand or adds to it lol)

I got an everlast 200dv love it.

Sent from my iPhone using Tapatalk

CroomWelder · Tue Jun 13, 2017 2:11 pm

The ck machine id pretty to look at. Nice looking machine.. its also (Mr Tig Approved) lol. Whatever that means or adds to it lol..

I have an everlast 200 dv and love it.

Cheaper then the lincoln square wave and razorweld.

Has pulse with controll, nice basic style torch and foot petal. No bulky acessories.

Sent from my iPhone using Tapatalk