Welding Certification test Q&A and tips and tricks
AWS D1.5 Certification
Post Reply
Joseph~
  • Posts:
  • Joined:
    Mon Jan 13, 2014 9:42 pm

Looking for practical tips / advice for taking AWS D1.5 using GMAW

3G and 4G positions

Coupon 1" thick x 7" long. 22.5 degree bevel each side, 45 degree opening with a 1/8 gap, 3/8" backing bar x 3"

1/16" flux wire with 100% CO2

285 ipm at 26.5 volts using a LN-25 PRO Dual Power feeder

Both 3g and 4g coupons will be X -Rayed

Any Advice?

Joseph
Top
User avatar
  • Posts:
  • Joined:
    Thu Jan 06, 2011 11:40 pm
  • Location:
    Near New Orleans

Yes, hello to you, too!

Thanks for the introduction... ;)

I'm moving your topic to the "certifications" category, where that topic is discussed.

Steve S
Top
User avatar
  • Posts:
  • Joined:
    Thu Jan 06, 2011 11:40 pm
  • Location:
    Near New Orleans

We are a network of friends, here.

If you wish to be in a network of friends, who share and help each other, then, welcome!

If you just want to show up and throw a question in the wind....

Steve S
Top
User avatar
  • Posts:
  • Joined:
    Fri Apr 01, 2011 10:59 pm
  • Location:
    Australia; Victoria

Like button,.....
Top
Mike
  • Posts:
  • Joined:
    Mon Dec 06, 2010 1:09 pm
  • Location:
    Andover, Ohio

Welcome to the forum Joseph.
M J Mauer Andover, Ohio

Linoln A/C 225
Everlast PA 200
Top
User avatar
  • Posts:
  • Joined:
    Wed Oct 23, 2013 3:30 pm
  • Location:
    Palmer AK

Welcome Joseph
Glad you decided to pull in ;)
John
Just a couple welders and a couple of big hammers and torches.

Men in dirty jeans built this country, while men in clean suits have destroyed it.
Trump/Carson 2016-2024
Top
User avatar
  • Posts:
  • Joined:
    Thu Jan 24, 2013 10:13 pm
  • Location:
    Eddy, TX

Joseph,
How did your test turn out?
Top
Post Reply

Return to “Welding Certification - Stick/Arc Welding, Tig Welding, Mig Welding Certification tests - Welding Tests of all kinds”