Page 1 of 1
CNC parts
Posted: Mon Aug 24, 2015 3:00 pm
by plain ol Bill
Running low on some parts today so sat a sheet of 3/8 on the table and cut out enough to last until the next time I am low. Hypertherm sure can cut some nice parts. Nested them up so there was just 1/8" between parts. Found out today my new Miller digital hood doesn't cooperate with noise ear muffs - gotta go to the store and get some ear plugs if I want to use the hood with the plasma.
Re: CNC parts
Posted: Tue Sep 15, 2015 3:41 pm
by EDMM
What CNC/table/cutter arrangement is that? Are you happy with it?
Re: CNC parts
Posted: Tue Sep 15, 2015 6:34 pm
by plain ol Bill
My table is self designed and built. The electronics are from CandCNC and the plasma unit is a Hypertherm 1250 with an upgraded DuraMax machine torch. Pleased - yeah I have to admit I am. It holds dimensions very well. I am really happy that I bought a Hypertherm rather than another brand.
Re: CNC parts
Posted: Wed Sep 16, 2015 1:37 am
by ex framie
Nice setup.
What are the parts for Bill?