plain ol Bill
- plain ol Bill
-
Guide
-
Posts:
-
Joined:Wed Apr 08, 2015 6:46 pm
-
Location:Tenino, WA
Running low on some parts today so sat a sheet of 3/8 on the table and cut out enough to last until the next time I am low. Hypertherm sure can cut some nice parts. Nested them up so there was just 1/8" between parts. Found out today my new Miller digital hood doesn't cooperate with noise ear muffs - gotta go to the store and get some ear plugs if I want to use the hood with the plasma.
- Attachments
-
- 126.JPG (43.63 KiB) Viewed 1084 times
-
- 125.JPG (71.86 KiB) Viewed 1084 times
-
- 124.JPG (67.36 KiB) Viewed 1084 times
Tired old welder
CNC plasma cutter
Colorful shop w/
Red, blue, yellow, purple, and Hypertherm silver equip.
CNC plasma cutter
Colorful shop w/
Red, blue, yellow, purple, and Hypertherm silver equip.
plain ol Bill
- plain ol Bill
-
Guide
-
Posts:
-
Joined:Wed Apr 08, 2015 6:46 pm
-
Location:Tenino, WA
My table is self designed and built. The electronics are from CandCNC and the plasma unit is a Hypertherm 1250 with an upgraded DuraMax machine torch. Pleased - yeah I have to admit I am. It holds dimensions very well. I am really happy that I bought a Hypertherm rather than another brand.
Tired old welder
CNC plasma cutter
Colorful shop w/
Red, blue, yellow, purple, and Hypertherm silver equip.
CNC plasma cutter
Colorful shop w/
Red, blue, yellow, purple, and Hypertherm silver equip.
