Page 1 of 1

Plasma cutter question.

Posted: Tue Dec 28, 2021 5:47 pm
by Jesse1973
I am currently in the process of researching plasma cutters.I have a 50 amp welding outlet in my garage .One of the cutters I am looking at says up to 60 output but 46 amp input.This prompted the question .Do plasma cutters have a current surge upon startup like motors ?Will i be okay with the 50 amp circuit or would I need 60?Or get a smaller cutter that requires less amperage?


Sent from my iPhone using Tapatalk

Re: Plasma cutter question.

Posted: Tue Dec 28, 2021 5:50 pm
by Oscar
You'll be just fine. I have a 55A plasma cutter that draws around 50A max, and it's just fine on a 50A circuit breaker.

Re: Plasma cutter question.

Posted: Tue Dec 28, 2021 5:54 pm
by Jesse1973
I was hoping I would be okay with the current welding circuit .


Sent from my iPhone using Tapatalk