Page 1 of 1
Beginner in welding
Posted: Mon Jul 17, 2017 12:10 am
by Beastly Weldz
Gonna keep it nice and short. Im in welding school at the moment and im trying to learn as much as possible. I want to soon have a little shop. I dont have much tools but what i want is advice and opinions. Im starting to post stuff online if yall would like to help.
My Facebook page is, Beastly Weldz.
Also on Youtube is, Beastly Weldz.
Question, should I 1st get a plasma cutter or torch?
Re: Beginner in welding
Posted: Mon Jul 17, 2017 7:32 am
by Artie F. Emm
Welcome to the forum! Are you thinking of opening a shop to provide services as a business, or a shop for your use?
Re: Beginner in welding
Posted: Mon Jul 17, 2017 7:51 am
by Mike
Welcome to the forum.
Both.
Re: Beginner in welding
Posted: Mon Jul 17, 2017 8:49 am
by cj737
start with an Oxy torch. You can use it to preheat, bend, and post heat, as well as cut. Plasma only enables cutting.
Re: Beginner in welding
Posted: Mon Jul 17, 2017 2:20 pm
by Beastly Weldz
Right now my goal is to have a shop open where i can do custom projects. I do have a oxy torch class coming up in the fall this year. Ball park range how much does it cost to buy the torch? And also run the torch?
I probably won't be cutting anything thicker than 1/4. Thats why i was thinking plasma cutter.
If i had the money i would do both lol
Re: Beginner in welding
Posted: Tue Jul 18, 2017 9:12 am
by thatoneguy
Both would ideally be best. But, if you're planning on just being a fab shop and not typically working with anything other than mild, stainless, or aluminum, I would get the plasma and a good compressor behind it. Can cut anything that will conduct lee trinity unlike a torch where you're limited to ferrous steels only, and it much cheaper to operate. I have the everlast plasma 80S and can attest that it is a BEAST. Granted I have a full torch rig too but it hardly gets used anymore.