Page 1 of 1
Questions about getting a pipe bender
Posted: Wed Jan 11, 2017 5:34 pm
by christiankeith90
Hey everybody, hopefully this post is in the right section. I'm wanting to buy a pipe bender, but I'm a little overwhelmed with all the options. I'd like to be able to bend pipe, square tubing, and flat bar. I've found some manual pipe benders but I'm overwhelmed with all the dies and everything, and none of them really bend flat bar. Is there any machine that I can do all this with and not spend a fortune. I'm fine with spending some money on it but I don't really know where to begin. Thanks for the help!
Re: Questions about getting a pipe bender
Posted: Thu Jan 12, 2017 7:36 am
by Poland308
Hossfeld bender.
Re: Questions about getting a pipe bender
Posted: Thu Jan 12, 2017 12:12 pm
by exnailpounder
christiankeith90 wrote:Hey everybody, hopefully this post is in the right section. I'm wanting to buy a pipe bender, but I'm a little overwhelmed with all the options. I'd like to be able to bend pipe, square tubing, and flat bar. I've found some manual pipe benders but I'm overwhelmed with all the dies and everything, and none of them really bend flat bar. Is there any machine that I can do all this with and not spend a fortune. I'm fine with spending some money on it but I don't really know where to begin. Thanks for the help!
You can pick up a bender used or even new for pretty cheap but they rape you on the dies. Watch Craigslist.