I have a project idea where I would like to take a flat piece of stainless and turn it into a foot stool with a trapezoid shape.
Any help/suggestions would be greatly appreciated
- TRACKRANGER
-
Weldmonger
-
Posts:
-
Joined:Wed Aug 06, 2014 12:48 am
-
Location:Melbourne, Australia
A trapezoid normally has 4 sides, although one may be left open.
Bending the stainless is probably your real question?
What type of bar E.g. 304, 316 etc will affect how easily it will bend.
Do you have bending equipment?
Can you bend past 90 degrees?
Do you have the ability to heat (e.g.Oxy/Acetylene)
Let us know what resources you have and it will help to get more accurate answers.
Ranger
Bending the stainless is probably your real question?
What type of bar E.g. 304, 316 etc will affect how easily it will bend.
Do you have bending equipment?
Can you bend past 90 degrees?
Do you have the ability to heat (e.g.Oxy/Acetylene)
Let us know what resources you have and it will help to get more accurate answers.
Ranger
EWM Phonenix 355 Pulse MIG set mainly for Aluminum, CIGWeld 300Amp AC/DC TIG, TRANSMIG S3C 300 Amp MIG, etc, etc